Skip to content

Testing (OneAPI)⚓︎

If you are using our CloudBoxx API, please use this documentation.

After telematics units are successfully installed and configured, the connection between telematics unit and vehicle as well as the telematics unit itself should be tested. To open Testing, you can either select Start test after completing the configuration or tap Testing on SmartControl’s home screen and select an available connected vehicle.

Testing Home Config Success

Available tests⚓︎

Two types of tests are available: Commands tests and Vehicle status tests . It is recommended you complete both types of tests before using the telematics unit to ensure it is configured correctly.

Testing Home

Commands⚓︎

Verify that the vehicle commands are working as intended by executing them with the buttons on screen. After sending a command, check whether it was successfully executed on the vehicle. For example, after pressing Lock top case, try opening the vehicle’s top case. Depending on whether the test was successful, select either Failed or Passed.

Testing Commands Testing Commands

Vehicle state⚓︎

Verify that the status data the telematics unit is displaying is correct. For example, this can include the current position or the status of the vehicle’s top case. Mark any false data as incorrect. Wrong values are usually caused by a faulty configuration or wiring.